Air Hydraulic Pump 10,000 PSI, 1.7L with Air Line Lubricator, Red

  
Out Put Pressure: 10000Psi(700bar), Input Air Pressure: 100-150Psi(7-10.5bar). Air Hydraulic Pump Interface Size, Air Inlet 1/4NPT, Oil Out Outlet 3/8NPT. Air consumption(under 100psi/6.9bar): 11 SCFM0.31 cu. Output Flow Rate: 1.7L(104cu. Output Flow Rate NO LOAD: 850ml/min(52cu.

Output Flow Rate (in3/min) LOAD: 170ml/min(10cu. 10,000 PSI air/hydraulic foot pump requires 100-150 PSI air pressure.

Designed to be used with single acting cylinders. Provides hands free operation for pumping and releasing load. Usable fluid capacity 98 cubic inches. With no load, 8.5 cu. Complies with ASME PALD/2009 Safety Standards. Fast Acting With 1700cc Oil Reservoir. For Use On Ram Cylinders From 10 Ton Up To 40 Ton Capacity.

Includes 5 Foot High Pressure 700 Bar (10,000 Psi) Hose And Coupler. Includes 4 Foot Compressed Air Line With Air Control. Input Air Pressure: 100-150Psi (7-10.5bar).

Out Put Pressure: 10000Psi (70bar). Air consumption (under 100psi/6.9bar) : 11 SCFM 0.31 cu.

Our piston can be opened to access and change the seal inside. Plastic pistons are factory sealed and can only be replaced. We now use TEFLON SEALS on the piston they last longer perform better and withstand the heat very well. So many of these pumps are using steel metal piston sleeves & as you know compressed air carries water in it.

The water in the air will corrode this sleeve, tear the seals, and seize the piston. This sleeve corrosion renders the pump dead as the cost to replace (If it is even available as a part) is very high. Our pump has an aluminum sleeve with a proprietary anti corrosion coating. Although excessive water will ruin any pump our sleeve will last a very long time. As the pump pushes oil out it must inhale air into the reservoir.

These plastic plugs are constant.